Beep Code Manual-AMI Motherboard

When a computer is first turned on, or rebooted, its BIOS performs a power-on self test (POST) to test the system's hardware, checking to make sure that all of the system's hardware components are working properly. Under normal circumstances, the POST will display an error message; however, if the BIOS detects an error before it can access the video card, or if there is a problem with the video card, it will produce a series of beeps, and the pattern of the beeps indicates what kind of problem the BIOS has detected.

Because there are many brands of BIOS, there are no standard beep codes for every BIOS.

Below are listed the beep codes for AMI systems.

AMI Beep Codes

• 1 beep DRAM refresh failure. There is a problem in the system memory or the motherboard.
• 2 beeps Memory parity error. The parity circuit is not working properly.
• 3 beeps Base 64K RAM failure. There is a problem with the first 64K of system memory.
• 4 beeps System timer not operational. There is problem with the timer(s) that control functions on the motherboard.
• 5 beeps Processor failure. The system CPU has failed.
• 6 beeps Gate A20/keyboard controller failure. The keyboard IC controller has failed, preventing gate A20 from switching the processor to protect mode.
• 7 beeps Virtual mode exception error.
• 8 beeps Video memory error. The BIOS cannot write to the frame buffer memory on the video card.
• 9 beeps ROM checksum error. The BIOS ROM chip on the motherboard is likely faulty.
• 10 beeps CMOS checksum error. Something on the motherboard is causing an error when trying to interact with the CMOS.
• 11 beeps Bad cache memory. An error in the level 2 cache memory.
• 1 long beep, 2 short Failure in the video system.
• 1 long beep, 3 short A failure has been detected in memory above 64K.
• 1 long beep, 8 short Display test failure.
• Continuous beeping A problem with the memory or video.